How To Install Nissan 1400 Electronic Distributor

If you own a Nissan 1400, you might want to consider upgrading to an electronic distributor. An electronic distributor can give you more control over your engine's timing and can result in improved performance, better fuel economy, and smoother idle. In this article, we will guide you through the steps of installing a new electronic distributor in your Nissan 1400.

Gather Your Tools and Materials

Before you begin, make sure you have all the necessary tools and materials:

• New electronic distributor
• Socket set
• Screwdrivers
• Timing light
• New spark plugs (optional)

Remove the Old Distributor

The first step is to remove the old distributor. Start by disconnecting the battery to avoid any electrical shocks.

1. Begin by removing the distributor cap.
2. Loosen the bolt that holds the distributor in place.
3. Slowly pull the distributor out of the engine block while taking note of the orientation of the rotor.
4. Remove the distributor shaft from the engine block.
5. Remove the old distributor gasket.

Install the New Electronic Distributor

Now that the old distributor is out, it's time to install the new electronic distributor:

1. Install the new gasket on the engine block.
2. Insert the new distributor shaft into the engine block, taking care to align it with the oil pump shaft.
3. Place the new electronic distributor in place and finger tighten the bolt to hold it in place.
4. Set the rotor in the same position as the old distributor.
5. Rotate the distributor until the rotor is pointing at the number one cylinder on the distributor cap.

   Note: This varies depending on the engine layout so consult your manual to find the right position.

6. When the rotor is pointing to the number one cylinder, tighten the bolt of the electronic distributor.

Connect the Electrical Wires

Now that the new distributor is installed, it's time to connect the electrical wires:

1. Start by connecting the engine's wiring harness to the new electronic distributor. This connector is typically located on the side of the distributor housing.
2. Connect the distributor to the ignition coil. You may need to replace your old coil with a new one.
3. Connect the spark plug wires to the distributor cap in the correct order (again, consult your manual for the correct firing order).

Adjust the Timing

With the distributor installed and the wires connected, it's time to adjust the timing:

1. Reconnect the battery.
2. Start the engine and let it warm up to operating temperature.
3. Use a timing light to adjust the timing. Refer to your car's manual for the correct timing procedure.

Conclusion

Installing a new electronic distributor is a job that can be done by any car owner with basic mechanical skills. With the right tools and instructions, you can upgrade your Nissan 1400 to a more efficient and reliable engine.