Automatic water pump pressure controller is an essential component of any water pumping system. It maintains the pressure of water in the system, thus ensuring uninterrupted water supply throughout the day. The pressure controller units are designed to switch the water pump on and off automatically based on the water pressure in the system. If you are facing low water pressure issues or inconsistent water supply, then you need to adjust the automatic water pump pressure controller.
Step-by-Step Guide on Adjusting Automatic Water Pump Pressure Controller
Step 1: Turn off the power
The first step is to turn off the power supply of the water pump to avoid any electrical hazard. You can turn off the power switch on the main electrical panel box. If your water pump does not have a dedicated switch, then turn off the main power supply of the home.
Step 2: Access the Pressure Controller Unit
The second step is to find the pressure controller unit. It is usually located near the water pressure tank. Check the user manual if you are unable to locate the pressure controller unit.
Step 3: Check the Pressure Settings
The next step is to check the pressure settings of the pressure controller unit. The settings are different for every pump, and you can find them by looking at the control panel on the unit. The two pressure settings you need to check are:
Cut-in pressure: The pressure at which the water pump turns on
Cut-out pressure: The pressure at which the water pump turns off
Step 4: Adjust the Pressure Settings
The fourth step is to adjust the pressure settings of the pressure controller unit. To adjust the settings, use a screwdriver to turn the cut-in pressure adjustment screw and the cut-out pressure adjustment screw to the desired pressure level. You can also use a wrench or pliers instead of a screwdriver. Remember to adjust one setting at a time, and then test the water pressure before adjusting the next setting.
Step 5: Test the Water Pressure
After adjusting the pressure settings, turn on the power supply of the water pump and test the water pressure by turning on the faucet. If the water pressure is consistent and adequate, then you have successfully adjusted the pressure controller unit. If not, repeat the steps and adjust the pressure settings again.
Final Thoughts
In conclusion, adjusting the automatic water pump pressure controller is not a difficult task, but it requires some precautions and attention to detail. You need to turn off the power supply of the water pump, locate the pressure controller unit, check the pressure settings, adjust the pressure settings, and then test the water pressure. The ideal pressure settings depend on the type of water pump and the water supply system. If you are unsure about the pressure settings or unable to adjust them, then you can call a professional plumber or electrician for assistance.
