How To Program A Centurion Gate Remote With Another Remote

How To Program A Centurion Gate Remote With Another Remote

Have you bought a new Centurion gate remote but have no idea how to program it with your existing remote? Fret not, as we have the perfect solution for you. In this article, we will provide you with a step-by-step guide on how to program a Centurion gate remote with another remote.

👉 Learn More 👈
Table
  1. What is a Centurion gate remote?
  2. Things you will need
  3. Step-by-Step Guide
    1. Step 1: Reset your receiver
    2. Step 2: Locate the learn button
    3. Step 3: Press and hold the learn button
    4. Step 4: Press the button on the reference remote
    5. Step 5: Press the button on the new remote
    6. Step 6: Test the new remote
  4. Conclusion

What is a Centurion gate remote?

A Centurion gate remote is a device that is used to open and close automatic gates. It works with a receiver that is installed inside the gate opener. The remote sends a signal to the receiver when the button is pressed, which then triggers the gate to open or close.

Things you will need

  • Two Centurion gate remotes (one to be programmed and the other as the reference)
  • Access to the gate opener receiver
  • The gate remote manual (if available)

Step-by-Step Guide

Step 1: Reset your receiver

Before programming your new Centurion gate remote, you need to reset your receiver to clear out any previously stored codes. This can be done by using the reset button on the receiver or by disconnecting it from the power source for a few seconds and then reconnecting it.

Step 2: Locate the learn button

The next step is to locate the learn button on the receiver. This button is usually located on the back of the receiver and is labeled "Learn" or "Program". Consult your gate remote manual if you are unable to locate it.

How To Install Aluminium Sliding Door
READ

Step 3: Press and hold the learn button

Once you have located the learn button, press and hold it down until the LED light on the receiver begins to blink.

👉 Learn More 👈

Step 4: Press the button on the reference remote

With the learn button still pressed, press and hold the button on the reference remote that you want to use as a reference for the new remote. Hold the button down until the LED light on the receiver stops blinking and turns off.

Step 5: Press the button on the new remote

Next, press and hold the button on the new Centurion gate remote that you want to program. Hold the button down until the LED light on the receiver begins to blink again, indicating that the new remote has been successfully programmed.

Step 6: Test the new remote

Finally, test the new remote by pressing the button to open or close the gate. If the gate opens or closes, the new remote has been successfully programmed and is ready to use.

Conclusion

Programming a Centurion gate remote with another remote is a simple process that can be done in just a few easy steps. With our step-by-step guide, you can now easily program your new remote and start using it to open and close your automatic gate with ease.

/* */ Go up

This website uses cookies to offer you a better browsing experience, if you continue browsing we consider that you accept their use. Read more